Test Cell 2

3 MW, 3600 rpm Motor/Dyno with Variable Frequency Drive
Gearbox with interchangeable gear sets
- 47,000 rpm max, 308 ft-lb torque (420 Nm)
- Additional gear sets can be acquired for other torque/speed requirements, gearbox designed to minimize cost of replacement
Independent data acquisition and control system
Connections to air plant hot and cold header available as needed
Cell mass flow capability
- 20 lbm/sec, 9 kg/sec
- Higher mass flow possible depending on installation
- Atmospheric inlet condition available dependent on installation
Calibrated flow measurement systems
Inlet temperature: 1200° F max (650° C)
Exit temperature: 800° F max (427° C)
Inlet total pressure: 180 psia max (1240 kPA)
Secondary flow system
- Up to 17 circuits
- Individual flow controls and measurements
- Reconfigurable and relocatable to other cells
Multiple lubrication systems available